OPERATION MANUAL FOR PCS100HV
34
1. All PCSs ID are set through hardware switch, refer to the chapter “ID setting switches” of PCS100HV-IM.pdf for how to set.
2. For parallel system mode, only the register [0610] need to be configured one by one. Except the configured PCS can be powered on, the other PCS
need to be powered off. For the other registers, the upstream controller or EMS only needs to communicate with the Master for parameter
configuration, and the Master will copy these parameters to each slave via broadcast mode.
3. After setting parameters, Power off PCSs and power on them again.
To Next Page
Loading...
