Denon AVR-1908 Owner's Manual

ENGLISH
Room EO
Select room EO setting method.
[Selectable items]
~ :Apply settings to all surround modes.
Assign :Make settings for each surround mode separately.
Direct Mode Setup
.~:':.~:~ _ ,.~~.'~r:\~.~: ",~. ~ .
5e1e¢t .SeftifigS fdr room E9 .. miC. ~tc ..
Select room EO use for DIRECT or PURE DIRECT mode.
II Parameter Check
Check auto setup measurement results.
This
is displayed after the auto setup procedure is completed.
[Selectable items]
Speaker Config. Check Distance Check
Channel Level Check CrussoverFfeq.Check
EQCheck
[Selectable items]
ON Use room EO.
~: Do not use room EO.
~
The auto setup results can be set again when "Restore" is selected.
the • Check the polarities of the displayed speaker.
•
For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct. select "Skip':
• Displayed speaker could not
be detected. • Check the connections of the displayed speaker.
·
The front R speaker were not properly
detected.
Only one channel of the surround speakers
was detected.
· Sound was output from the R channel
when only one surround
back speaker was
connected.
·
The surround back, but the surround speaker
was not detected.
• Displayed speaker connected with
polarities reversed.
IJ~Front
... ,.1 .• 4
Ret r y ~
Cancel~
Ski ~
Ret r y ~
Cancel~
IJ~Front
Ret r y ~
Cancel ~
• Too much noise in the room for accurate. Either turn off any device generating noise or move it
measurements to
be made. away.
•
Try again when the surroundings are quieter.
• Speaker or subwoofer sound
is too low for • Check the speaker installation and the direction in
accurate measurements to be made. which the speakers are facing.
• Adjust the subwoofer's volume.
Auto Setup
Audwe\ Mu It EQ
=~~ t4l!i~' I,M
~ § &
• Included setup microphone is not connected. • Connect the included setup microphone to the SETUP
MIC jack on the main unit.
• Not
all speakers could be detected. • Check the speaker connections.
Auto Setup
AudWe& Mu It EQ
=~= l4~"~' I,N
~ § &
•
'~i Select "Retry" to measure again.
'N,O_ Be sure to turn the power off before checking the speaker connections.
23

Denon AVR-1908 Specifications

General

Channels	7.1
Power Output	90W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
HDMI Inputs	2
HDMI Outputs	1
Dolby Digital	Yes
DTS	Yes
Type	AV Receiver
Component Video Inputs	3
Component Video Outputs	1
Digital Audio Inputs	2 Optical, 2 Coaxial
Tuner	AM/FM
Frequency Response	10Hz-100kHz (+1, -3dB)
Input Sensitivity/Impedance	200mV/47k ohms
Signal-to-Noise Ratio	98 dB
Power Consumption	460W
Surround Sound Formats	Dolby Digital, DTS
Total Harmonic Distortion	0.08%
Tuner Frequency Range	AM: 522-1611 kHz, FM: 87.5-108.0 MHz
Standby Power Consumption	Less than 1W