ENGLISH
[Front!
Main Remote Control Unit
s
c:
~
N
o
::
'"
I
1Set
[MODE
SELECTOR
1]
to "AUDIO" or "VIDEO".
*Set to the AUDIO side for the
CD
or
TAPE/CD-R/MD position,
and
to the
VIDEO
side for the
DVDNDp,
SAT/CABLE,
VCR
or
TV
position.
•
The
signals for the pressed buttons
are
emitted while setting the
preset memory.
To
avoid
accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending
on
the model
and
year
of manufacture, this function
cannot
be
used for some models,
even
if they
are
of makes listed
in
the list of preset codes.
• Some manufacturers
use
more
than
one
type of remote control code.
Refer to the included list of preset codes to change the number
and
verify correct operation.
•
The
preset memory
can
be
set for
one
component only among the
following: TAPE/CD-R/MD, DVDNDP
and
SAT/CABLE.
~
Operating Preset Components
3Operate the component.
*
For
details, refer to the component's operating instructions.
*Some models cannot
be
operated with this remote control unit.
2
Set
[MODE
SELECTOR
2]
to
the component you want
to operate.
Presetting
• DENON and other makes of components
can
be operated by
setting the preset memory.
•
This
remote control unit
can
be used to operate components
of other manufacturers without using the learning function
by
registering the manufacturer of the component
as
shown
in
the
list of preset codes
(I2rEnd
of this manual).
• Operation
is
not possible for some models.
3Operate the audio component.
*
For
details, refer to the component's operating instructions.
*While this remote control
is
compatible with a wide
range
of
infrared controlled components, it may
be
the
case
that some
component models cannot
be
operated with this remote control.
1Set
[MODE
SELECTOR
1]
to "AUDIO" or "VIDEO".
*Set to the AUDIO side for the
CD
or
TAPE/CD-R/MD position,
and
to the
VIDEO
side for the DVDNDp,
SAT/CABLE,
VCR
or
TV
position.
2
Set
[MODE
SELECTOR
2]
to
the position for the
component to be operated (CD, iPodINETWORK or
TAPElCD-R/MD).
IOperating DENON Audio Components
1Set
[MODE
SELECTOR
1]
to "AUDIO".
2
Set
[MODE
SELECTOR
2]
to the component
to
be
registered.
[ZONE2
OFF]
(I
~:_,
_
~~I
[MAIN
ON]
[NUMBER]
~
0
GJ
CD!
:GJ
GJ
0:
..
_-~:
:---'
'_Wl
[MODE
_
-~1f::'l'~
[MODE
SELECTOR
1]
~~
SELECTOR
2]
Remote Control Unit Operations
[Rear]
Depending
on
the model
and
year of manufacture of your equipment,
some buttons may not operate.
3
Press
[ZONE2
OFF]
and
[MAIN
ON]
at the same time.
The
indicator starts flashing.
4
Referring to the included list
of
preset codes, press
[NUMBER]
to input the preset code
(a
3-digit number)
for the manufacturer
of
the component whose signals
you want to store in the memory.
5
To
store the codes
of
another component in the
memory, repeat steps 1 to 4.
48
To Next Page
Loading...
