ENGLISH
(RC-1077)
-N·n8
• Replace the batteries with new ones if the set does not operate
even
when the remote control unit
is
operated close to the unit.
•
The
supplied batteries
are
only for verifying operation.
• When inserting the batteries,
be
sure to do
so
in
the proper direction,
following the
"$"
and
"6"
marks
in
the battery compartment.
•
To
prevent damage or leakage of battery fluid:
• Do not
use
a new battery together
with
an
old one.
• Do not use
two
different types of batteries.
•
Do
not attempt to charge dry batteries.
•
Do
not short-circuit, disassemble, heat or dispose of batteries
in
flames.
• If the battery fluid should
leak,
carefully wipe the fluid off the inside
of
the battery compartment
and
insert
new
batteries.
• Remove the batteries from the remote control unit if it will not
be
in
use for long periods.
• When replacing the batteries,
have
the new batteries
ready
and
insert them
as
quickly
as
possible.
Point the remote control unit at the remote sensor when operating it.
Approx.
23
feet / 7 m
-N·n8
The
set may function improperly or the remote control unit
may
not
operate if the remote control sensor
is
exposed to direct sunlight,
strong artificial light from
an
inverter type fluorescent lamp
or
infrared
light.
(RC-l085)
(RC-l085)
R03/AAA
About
the
Remote Control
Unit
In
addition to the
AVR-1908,
the included main remote control unit
(RC-l077)
can
also
be
used to operate the equipment listed below.
CD
DENON
system components
@ Non-DENON system components
•
By
setting the preset memory (Gr'page 48 -
50)
CD
Lift the clasp
and
remove the rear lid.
@
Load
the
two
batteries properly
as
indicated
by
the marks
in
the
battery compartment.
®
Put
the
rear
cover
back
on.
*
!I://#####//kdO
w,,,
Cautions on Installation
Cautions
on
Handling
Note:
For
proper heat dispersal, do not install this unit
in
a confined
space,
such
as
a bookcase or similar enclosure.
• Before tuming
the
power switch on
Check once
again
that
all
connections
are
correct
and
that there
are
no problems with the connection cables.
• Power
is
supplied to some of the circuitry even when the unit
is
set to the standby mode. When traveling
or
leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• About condensation
If there
is
a major difference
in
temperature between the inside of
the unit
and
the surroundings, condensation (dew)
may
form
on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for
an
hour or
two
with the power
turned off
and
wait until there
is
little difference
in
temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result
in
noise. If
so,
move
the mobile phone away from this unit when it
is
in
use.
• Moving the unit
Turn
off the power
and
unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
• Note that the illustrations
in
these instructions
may
differ from the
actual unit for explanation purposes.
(")
o
:::>
:::>
'"
~
o'
:::>
'"
;)j
..
3
o
co
(")
o
;;
e.
I
3
To Next Page
Loading...
Need help?
General
