Before using
Pay attention to the following before using this unit:
•Moving the unit
To prevent short-circuits or damaged wires in the connection
cables, always unplug the power supply cord and disconnect the
connection cables between all other audio components when
moving the unit.
• Before turning the power switch on
Check once again that all connections are correct and that there
are not problems with the connection cables. Always set the
power switch to the standby position before connecting and
disconnecting connection cables.
• Store these instructions in a safe place.
After reading, store this instructions along with the warranty
card in a safe place.
• Note that the illustrations in these instructions may differ
from the actual unit for explanation purposes.
Advanced Setup – Part 1
Navigating through the System Setup Menu····················65
On screen display and front display ···································66
Audio Input Setup
Setting the Digital In Assignment·········································67
• Setting the DENON LINK···················································67
Setting the EXT. IN Setup···············································67, 68
Setting the iPod Assignment················································68
Setting the Input Function Level ··········································68
Setting the Function Rename···············································69
Tuner Presets ·································································69, 70
Video Setup
Setting the HDMI In Assignment·········································71
Setting the Component In Assignment··························71, 72
Setting the Video Convert ····················································72
Setting the HDMI Out Setup··········································72, 73
Setting the Audio Delay························································73
Setting the On Screen Display (OSD) ··································73
Advanced Playback
Setting the 2ch Direct / Stereo·············································74
Setting the Dolby Digital Setup ············································74
Setting the Auto Surround Mode ·········································75
Setting the Manual EQ Setup···············································75
Procedure for copying the “Flat” correction curve ··············76
Advanced Setup – Part 2
Speaker Setup
Setting the type of speakers ··········································82, 83
Setting the low frequency distribution ·································83
Setting the Distance·······················································83, 84
Setting the Channel Level ··············································84, 85
Setting the Crossover Frequency···································85, 86
Setting the crossover frequency individually
for the different channels ·····················································86
Selecting the surround speakers for the
different surround modes·····················································86
Others Setup
Setting the Room EQ Setup·················································87
Setting the Direct Mode Setup ············································87
Setting the MIC Input Select················································87
Check the parameter····························································88
System setup items and default values·······················89~91
Troubleshooting ··························································105, 106
Additional Information·················································92
~104
Specifications ······································································106
List of preset codes ····································End of this manual
Advanced Operation
Remote control unit
Operating DENON audio components ···························51, 52
Preset memory·····································································53
Operating a component stored in the preset memory ·····53 ~ 55
Learning function··································································56
System call ···········································································57
Punch through ······································································57
Setting the back light’s lighting time ····································58
Setting the ambient light sensor ··········································58
Setting the brightness ··························································58
Resetting ··············································································59
Multi zone music entertainment system
Multi-zone playback using the ZONE2
and ZONE3 PREOUT terminals ············································60
Multi-zone playback using the SPEAKER terminals ·············61
Outputting a program source to amplifier, etc.,
in the ZONE2 (or ZONE3) room
(ZONE2 or ZONE3 SELECT mode)·······································62
Remote control unit operations during
multi-source playback ···························································62
Other function
Playing Super Audio CDs with DENON LINK·······················63
Multi-source recording / playback·········································64
Last function memory ··························································64
Initialization of the microprocessor·······································64
Option Setup
Setting the Power Amplifier Assignment·····························76
Setting the Volume Control ··················································77
Setting the Trigger Out···················································77, 78
Setting the Display ·······························································78
Setting the Remote Control ···········································78, 79
Setting the iPod Charge ·······················································79
Setup Lock············································································79
Network Setup
Setting the IP Address ·························································80
Setting the Proxy··································································80
Setting the Network Option ·················································81
To Next Page
Loading...
