40
Basic Operation Basic Operation
1
Set the input source to “TUNER”.
2
Press the TU (TUNER) button
to select the TUNER mode.
3
Auto tuning Manual tuning
• When in the auto tuning mode on the FM band, the “STEREO”
indicator lights on the display when a stereo broadcast is tuned
in. At open frequencies, the noise is muted and the “TUNED”
and “STEREO” indicators turn off.
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the “STEREO” indicator turns off.
4
Press the MODE button to set the auto tuning
mode.
• “AUTO” indicator appears on the display.
5
Press the TUNING button.
• Automatic searching begins, then stops when a station is
tuned in.
• If tuning does not stop at the desired station, use to the
“Manual tuning” operation.
Listening to the radio
Check that the remote control unit is set to AMP or TUNER.
1
Set the input source to “TUNER”.
2
Press the TU (TUNER) button to select the
TUNER mode.
3
4
Press the MODE button to set the manual tuning
mode.
Check that the display’s “AUTO” indicator turns off.
Watching the display, press the BAND button to
select the desired band (AM, FM or XM).
When listening to the XM Satellite Radio ( page 42).
Watching the display, press the BAND button to
select the desired band (AM, FM or XM).
When listening to the XM Satellite Radio ( page 42).
5
Press the TUNING button to tune in the desired
station.
The frequency changes continuously when the button is
held in.
(Main unit) (Remote control unit in the AMP mode)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
