Denso BHT-1600 - Page 166

154
BHT-1600 Handy Terminal User Manual
Chinese 25 Disable
Chinese 25 Switch to enable Chinese 2 of 5 decoding. Disable
Discrete 25 Enable
Discrete 25 Switch to enable Discrete 2 of 5 decoding. Enable
Length option Sets the length of the Discrete 2 of 5 symbols to decode.
 One Fixed length (Length 1)
 Two Fixed lengths (Length 1>Length 2)
 Max / Min Length (range: 0-55; Length 1<Length 2)
 Any Length
Max / Min
Length
(4-55)
Interleaved 25 Enable
Interleaved 25 Switch to enable Interleaved 2 of 5 decoding. Enable
Length option
Sets the length of the Interleaved 2 of 5 symbols to
decode.
 One Fixed length (Length 1)
 Two Fixed lengths (Length 1>Length 2)
 Max / Min Length (range: 0-55; Length 1<Length 2)
 Any Length
Max /
Min
Length
(4-55)
Verify Check Digit Decide whether to verify the check digit. If desired, select
one of the algorithms below. If the check digit is
incorrect, the barcode will not be accepted.
 Disable
 USS Check Digit
 OPCC Check Digit
Disable
Transmit Check Digit
Decide whether to include the check digit in the data
being transmitted.
Disable
Convert To EAN-13 Convert a 14-character Interleaved 25
barcode into
EAN-13 if the following requirements are met:

The barcode must have a leading 0 and a valid
EAN-13 check digit.
Disable
Matrix 25 Enable
Matrix 25 Switch to enable Matrix 2 of 5 decoding. Disable
Length option Sets the length of the Matrix 2 of 5 symbols to decode.
 One Fixed length (Length 1)
 Two Fixed lengths (Length 1>Length 2)
 Max / Min Length (range: 0-55; Length 1<Length 2)
 Any Length
Max / Min
Length
(4-55)
Redundancy Enables or disables read redundancy for Matrix 2 of 5. Disable
Verify Check Digit Select whether to verify the check digit, which is the last
character of the barcode.
If the check digit is incorrect,
the barcode will not be accepted.
Disable