Derby cycle Impulse Evo - 12. Torque settings

EN-100 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
Donotswitchthepedelecowhilstyouareridingit.Thiscancutoutthemotorormeanyoudonotreceivefullassist.
11.2 Battery
Display Description Cause Remedy

5LEDsashquickly
after the battery button is
pressed.
a)Batteryisatandisdisabled. a)Ifthebatteryisat,itwillworkagainbrieyafterashortrecoveryperiod,thenswitcho
again. It must now be charged  10.3.1 Charging a battery Page EN-93.
b) The battery is overloaded. b) If the battery is overloaded, it switches itself on again after a short rest period and can be used
again as normal.
c) The battery is too cold or too hot. c)Thepermittedambienttemperaturerangeduringoperationrangeofthebatteryis-10to+40˚C.

The1stLEDashes
rapidly after pressing the
battery button.
There is a charging fault.
Unplug the charger from the mains immediately. If the problem reoccurs, a new battery
charger is required.
No LEDs light up after
pressing the battery
button.
The battery is faulty. Please contact your cycle dealer. The battery must be replaced.
The range appears too
short
a) The range depends on:
» Rideprole
» Assist mode
» Tyre pressure
» Riding style
» Physical condition
» Overall weight
» Outside temperatures
» Battery capacity
» The route selected
» Smartphone charging via display
a) The are many reasons why the range may seem low  9.4.1 Range Page EN-88.