Voice over IP (VoIP) OpenPhone IPC
116
9.5.2 Configuration
Analogue to the VoIP system telephones, the OpenPhone IPC creates multiple IP
connections to the OpenCom 100. When you start the program for the first time,
the Options dialogue is automatically opened. Here you must configure the fol-
lowing values:
1. Enter in the VoIP IP Address field the OpenCom 100’s IP address.
2. Enter six hexadecimal-digits into the Device ID field. This device ID is not a
MAC address, so overlapping with existent MAC addresses is possible. The
device ID is configured in the Configurator, on the PBX Configuration:
Devices: VoIP Phones page.
3. Confirm with OK.
Notes
VoIP system telephony requires an active IP connection to a workplace computer.
If a Firewall is installed for your workplace computer, you may need to explicitly
allow this connection.
If you log on to the workplace computer using a different user name, you must
reconfigure these values.
You can use any arbitrary sequence of digits not already in use in the LAN for the
device ID. Select a random device ID to secure telephone usage. The device ID can
only be read on the Web console.
The displayed menu texts and parts of the operations software are elements of the
OpenPhone IPC installation, but they can be loaded from the OpenCom 100 via
TFTP. where necessary
To Next Page
Loading...
