DETEWE OpenCom 130 - Address Queries Using LDAP

Configuring the PC Software Address Queries using LDAP
167
3. Open the Services dialogue under Start: Settings: Control Panel: Administ-
ration. Set the autostart type of the Windows Timer service to Automatic.
Start the service with Process: Start. Every time the service starts, the PC clock
is synchronised with the time of the OpenCom 100.
Please note: In a Windows domain network, the PDC server (primary do-
main controller) should automatically assume the function of
the timer.
SNTP with Windows XP
Here you configure the SNTP server by double-clicking on the time in the Start bar.
Enter the OpenCom 100 as the Server in the Internet time tab.
16.8 Address Queries using LDAP
You can search the data of the central telephone book of the OpenCom 100 from a
workstation in the LAN using LDAP (Lightweight Directory Access Protocol). When
configuring an LDAP-enabled program, specify the IP address of the
OpenCom 100 as the address of the LDAP server.
LDAP with Outlook Express
You can configure and operate the LDAP directory service with Outlook Express
TM
,
a Microsoft
TM
e-mail program, as follows:
1. Call up the Accounts command in the Tools menu.
The Internet Accounts dialogue box will then open.
2. Click on Add. Select the Directory Service command from the pop-up menu.
The Internet Connection Wizard dialogue box for Internet access will then
open.
3. Under Internet directory (LDAP) server, enter the address of the
OpenCom 100. It is not necessary to log in to the LDAP server. Click twice on
Next. Then click on Finish.
4. Check the function. In the Edit menu, call up the Find: People command.
The Find: People dialogue box will then open.