Multi-Company Variant Configuring the Multi-Company Variant
153
15.1 Configuring the Multi-Company Variant
The multi-company variant can be commissioned and configured by the system
administrator of the OpenCom 100 without any major effort. In the multi-
company variant, the communications system behaves in exactly the same way as
the single-company variant. This is particularly of interest to users who want to
expand their own system and at the same time operate it in a group.
The process in brief:
1. The feature must be activated (see Activating the Multi-Company Variant
starting on page 153).
2. The required companies must be set up (see Configuring and Managing Com-
panies starting on page 154).
3. The users of the OpenCom 100 are assigned to the individual companies (see
Assigning Users starting on page 154).
4. In order that the OpenCom 100 can transfer incoming calls to the corres-
ponding company (or its staff) correctly, the existing trunk groups must be uni-
quely assigned to the companies (see Assigning Trunk Groups/SIP Accounts
starting on page 155).
5. In the case of outgoing external calls, the lines via which the members of a
company can make a call must be defined (see Allocating Routing Codes
starting on page 155).
6. An exchange must be set up for each company so that the OpenCom 100 can
correctly process statuses in which a call should be routed to the exchange (see
Configuring the Company Exchange starting on page 156).
15.1.1 Activating the Multi-Company Variant
To be able to configure several companies in the OpenCom 100, the “Multi-
company variant” (OpenCompany 45) program package must first be activated.
This is done in the Configurator on the Web console in the SYS Configuration:
Licences menu. The licence confirmation you received with the program package
contains all the information you require about how to proceed.
To Next Page
Loading...
