DECTnetIP Configuration
119
10.2 Configuration
One of the DECTnetIP base stations that is installed assumes coordination and
configuration of the DECT-over-IP functions (DECTnetIP-Manager). Select a base
station that has a dependable data link to the OpenCom 100. Go to the PBX Confi-
guration: Devices: DECTnetIP page in the Configurator. Enter the MAC address of
the base station that you have selected to be the DECTnetIP Manager. The MAC
address of the base station is located on its type label. Enter a fixed IP address for
this base station. All other base stations can be operated using either a fixed IP
address or an IP address assigned dynamically via DHCP. Configuration of the
DECTnetIP-Manager must work via a static DHCP entry. Please refer to the infor-
mation given in the chapter entitled LAN DHCP Server starting on page 111.
Note: A base station cannot be operated as a DECTnetIP Ma-
nager and a WLAN-Access Point simultaneously.
Create a separate entry for each DECTnetIP base station and for the DECTnetIP
Manager as well. You use these entries to determine the VoIP data compression
(Profile).
Configurator: PBX Configuration: Devices: DECTnetIP
User administration and set-up of DECT terminals is done in the Configurator of
the OpenCom 100 as well.
The DECTnetIP Manager offers a separate web user interface to manage the set-
tings of devices with WLAN functions. Therefore at least one WLAN-RFP has to be
configured. If everthing is configured correctly, you will see the WLAN Config link.
Login as the user “Administrator” with the currently set administrator’s password
of the OpenCom 100.
To Next Page
Loading...
