Configuration Configuring the OpenCom 100
81
Activation is automatically cancelled 30 minutes after the last configuration
activity.
Note: During remote configuration, the OpenCom 100 is
blocked for RAS access by any further users.
Please note: The system PIN is preset to “0000” and it is absolutely impe-
rative that the system administrator changes it to prevent
undesirable remote maintenance.
Using remote configuration, all OpenCom 100 settings (with the exception of the
system PIN) can be edited or updated. New software versions of the OpenCom 100
and the software for the connected system terminals and base stations can also be
installed (see the SYS Configuration: Firmware menu in the Configurator).
For security reasons, settings in the Configurator, Net Configuration should only
be edited on site to avoid malfunctions or failures in the customer’s LAN (e.g. due
to IP address conflicts). Refer to the chapter entitled Configuration Examples
starting on page 87, where interaction between the OpenCom 100 and a LAN is
explained.
Forced logoff of another user by the administrator
The configuration of the system can always only be edited by one user. Working on
the configuration in parallel is not possible. This ensures that no configuration
conflicts arise.
If the user “Administrator” logs in and another user with administration rights is
already logged in, then the administrator can forcibly log the other user off in
order to configure. This functionality, for example can be used, when configuring
remotely, when a user has forgotten to log out.
In order to forcibly log a user off:
1. The “Administrator” user logs on with the administration password.
2. They open the Configurator.
A message shows which user is currently configuring the system.
3. The administrator clicks on the Take over config rights button.
The other user can make no further modifications of the configuration.
To Next Page
Loading...
