DIEBOLD Service manual

To Next Page

To Previous Page

Replacing the accumulator

36 BEETLE /M-III - Service manual

– The menu appears in the following:

Select the menu item "LocalUPSMAN via TCP/IP".

– The UPS monitor opens.

Main Page

Default Chapter3
- Table of Contents3
1 Introduction5
- About this Manual5
2 Important Notes6
- Esd6
- System Maintenance6
- Tools Required6
- Safety Precautions6
3 Installation and Commissioning8
- Before Switching on8
4 Chassis Components9
5 Front View10
- External View with Hard Drive Access10
6 Rear View11
- Rear View with Labeling11
- Rear Side with UPS12
- Rear Side of O1 Motherboard12
7 Setting up the Device13
- Vertical Installation13
- Cabling the BEETLE /M-III14
8 Connecting the Device15
9 Assembling the Cable Cover17
10 Removing the Front Panel18
11 Detaching Cables19
12 Removing the Housing Hood21
13 Components of the System22
- Inside View22
- Inside View with UPS23
14 Storage Media24
- Replacing a 3.5" SATA Hard Disk24
- SATA Connections on K1/K2 or M1/M2 Motherboard25
- SATA Port on the O1 Motherboard26
- Replacing Two 2.5" Hard Drives or SSD27
- For Hard Disks or SSD with Front Access28
15 Using Photoconductors31
16 Replacing the Accumulator32
- Settings after the Replacement34
17 Replacing the Power Supply Unit38
- For a BEETLE /M-III with UPS40
18 Inserting Memory Extensions50
19 Replacing the Battery52
20 Changing Processors53
- Installation in Headwords56
21 Switching the Retail Card58
22 Replacing the Combination Module60
23 Replacing the Front USB Port62
24 Replacing 4Port USB Hubs65
25 Replacing COM5 and COM6 Interface67
26 Using the LPT Port70
27 Replacing the K1/K2 or M1/M2 Motherboard72
- Reset Password78
28 Replacing the O1 Motherboard79
29 Technical Information84
- Interfaces (K1/K2, M1/M2 Motherboard)85
- Interfaces (O1 Motherboard)86
- Total Current Consumption Interfaces87
30 Manufacturer´s Certification88
- Guarantee88
- Recycling88
- FCC-Class a Declaration88
31 Abbreviations90

DIEBOLD Service manual - Page 36

Table of Contents