Introduction
BEETLE /M-III - Service manual 5
1 Introduction
The BEETLE /M-III is equipped with the latest processors and has at its disposal a multitude of interfaces in order
to enable connection of any peripheral that is required in the area of the teller position.
The device has been developed and produced without the use of environmentally hazardous substances and with
the optimized use of electricity, gas and water. The construction materials used are largely recyclable.
1.1 About This Manual
NOTICE
Notes in the manual are marked by this symbol
CAUTION
Attention notifications are identified by this sign.
NOTICE
This description is addressed exclusively to Technical Service personnel!
Corresponding expertise in software and hardware configurations in the POS area, installation procedures, etc.
are therefore prerequisite.
The manual describes the BEETLE/M-III system with the motherboards K1/K2, M1/M2 and O1. The M1/M2 board
is preferred for display in the drawings, particularly for the installation/removal or opening of the system, which is
why the rear views and overall views may not correspond to the configuration of your particular system. You can
see the differences between the systems in the connection view.
In these Service instructions it is primarily the removal of components that is described. The installation of these
components always proceeds in the reverse order. Special assembly instructions can be found in the respective
sections as required.
Please read the entire documentation carefully before commencing any repair or maintenance measure.
To Next Page
Loading...