Changing processors
56 BEETLE /M-III - Service manual
20.1 Installation in headwords
Mount the processor carefully. While doing so, take care to ensure that the marking on the processer (two
notches) match those of the base (two lugs).
Close the processer base, reposition the lever and lock it.
NOTICE
Before the cooling element is used, the old thermal paste must be removed from the cooling element.
NOTICE
It is mandatory to apply some thermally conductive paste on the underside of the cooling element before attach-
ing the cooling element, as only doing so will ensure sufficient cooling. The contact surface between cooling ele-
ment and processer must be covered completely with a thin layer of paste. A corresponding kit with a new
counter-cross is enclosed with the new processer.
Set the cooling element on the processer and tighten the screws hand-tight in cross-wise sequence.
To Next Page