Changing processors
BEETLE /M-III - Service manual 53
20 Changing processors
This chapter does not apply for a BEETLE/M-III with an O1 motherboard.
Shut down the system. Remove the cable cover and pull the power plug at the rear.
Remove the housing hood.
NOTICE
Observe the instructions regarding electrostatic discharge-sensitive assemblies (see chapter "Electrostatic dis-
charge-sensitive components").
Fold the hard disk holder upwards and set it aside.
Remove the cables from the holders of the air duct. No air duct is installed for a BEETLE/M-III with O1
motherboard.
Remove the air duct upwards.
To Next Page