Important notes
BEETLE /M-III - Service manual 7
– When installing the device, please ensure that the device plug-in fixture and the protective contact electrical
socket are easily accessible.
– The device must be fully disconnected from the supply voltage when performing any work at the device and
when inserting or removing data cables. To completely disconnect the appliance from the mains voltage,
switch off the device and pull out the power plug of the power supply unit.
– USB devices may be connected to the BEETLE or removed from it during ongoing operations if these devices
comply with the specifications pursuant to usb.org. Other peripherals (e.g. PoweredUSB printer) should not –
for safety reasons – be connected to or disconnected from BEETLE systems unless such systems are switched
off.
– Before you begin any assembly work on the device, you should discharge yourself, e.g. by touching a grounded
object (such as a radiator).
– Please make sure that no objects (e.g. paperclips) are able to enter the inside of the device, as this may result
in electrical shocks or short circuits.
– Keep the air slots of the device free to ensure proper ventilation and please observe the installation instruc-
tions for the BEETLE. This prevents excessive increases in temperature.
– No data cables may be plugged in or unplugged during storms.
– Protect the device from vibrations, dust, moisture and heat.
– Make sure that used parts, e.g. the accumulator are disposed of in a way that is environmentally friendly.
– In the event of emergencies (e.g. damaged housing or damaged power cable, penetration of liquids or foreign
bodies), switch the device off immediately, pull the power plug and inform Technical Customer Service at
Diebold Nixdorf International GmbH or the authorized service partner of your dealer.
– An explosion hazard exists if the lithium battery of the device is replaced incorrectly. Only identical batteries or
other types recommended by the manufacturer are permitted to be used to replace the lithium battery.
– Your BEETLE system is the result of state-of-the-art technical innovation. Please ensure therefore equally
state-of-the-art constructional and technical ambient conditions to permit flawless and efficient functioning of
the BEETLE. You should connect the BEETLE or any other IT system only to power supply networks with sepa-
rate protective conductors (PE).
This type of power supply network is called a TN-S network. Do not use PEN conductors! Please also observe
the recommendations of DIN VDE 0100 part 540, Annex C2. This will help you avoid any potential malfunc-
tions.
– When replacing a storage medium, please ensure that you use only storage media authorized or recom-
mended by Diebold Nixdorf.
To Next Page