Digi XBee - Page 10

Specifications
XBee / XBee-PRO RF Modules 802.15.4 Product Manual 10
Transmit current (typical) 45 mA (@ 3.3 V) 250 mA (@3.3 V) (150 mA for
international variant) RPSMA
module only: 340 mA (@3.3 V)
(180 mA for international variant)
Idle / receive current (typical) 50 mA (@ 3.3 V) 55 mA (@ 3.3 V)
Power-down current < 10 uA < 10 uA
General
Operating frequency ISM 2.4 GHz ISM 2.4 GHz
Dimensions 0.960 in x 1.087 in (2.438cm x 2.761cm) 0.960 in x 1.297 in (2.438cm x 3.294
cm)
Operating temperature -40 to 85º C (industrial) -40 to 85º C (industrial)
Antenna options Integrated whip antenna, embedded
PCB antenna, U.FL connector, RPSMA
connector
Integrated whip antenna,
embedded PCB antenna, U.FL
connector, RPSMA connector
Networking and security
Supported network topologies Point-to-point, point-to-multipoint and
peer-to-peer
Number of channels
(software selectable)
16 direct sequence channels 12 direct sequence channels
Addressing options PAN ID, channel and addresses PAN ID, channel and addresses
Agency approvals
United States (FCC Part 15.247) OUR-XBEE OUR-XBEEPRO
Industry Canada (IC) 4214A-XBEE 4214A-XBEEPRO
Europe (CE) ETSI ETSI (Maximum 10 dBm transmit
power output)*
Japan R201WW07215214 R201WW08215111 (Maximum
10 dBm transmit power output)*
Wire, chip, RPMSA, and U.FL
versions are certified for Japan. PCB
antenna version is not.
Australia C-Tick C-Tick
Brazil ANATEL 0369-15-1209 ANATEL 0378-15-1209
*See Agency certifications on page 98 for region-specific certification requirements.
Table 1: Specifications of the XBee / XBee-PRO OEM RF Module
Specification XBee XBee-PRO