XBee / XBee-PRO RF Modules 802.15.4 Product Manual 36
XBee/XBee-PRO RF Module configuration
Programming the RF Module
Refer to Command Mode on page 33 for more information about entering Command Mode, sending
AT commands and exiting Command Mode. For information regarding module programming using
API Mode, refer to API Operation for the XBee/XBee-PRO RF Module on page 89.
Programming examples
Setup
The programming examples in this section require the installation of XCTU and a serial connection to
a PC. We stock RS-232 and USB boards to facilitate interfacing with a PC.
1. Download XCTU from Digi’s website here.
2. After the .exe file downloads to the PC, double-click the file to launch the XCTU Setup Wizard.
Follow the steps in the wizard to completely install XCTU.
3. Mount the RF module to an interface board, then connect the module assembly to a PC.
4. Launch XCTU and click the 'Add devices' tab on the upper left corner of the screen.
To Next Page
Loading...
Need help?
General
