XBee/XBee-PRO® S2C ZigBee® RF Module
10
NJ (Node Join Time) 230
JV (Channel Verification) 230
NW(Network Watchdog Timeout) 230
JN (Join Notification) 230
AR (Aggregate Routing Notification) 231
Security commands 231
EE (Encryption Enable) 231
EO (Encryption Options) 231
NK (Network Encryption Key) 232
KY (Link Key) 232
RF interfacing commands 232
PL (TX Power Level) 232
PM (Power Mode) 233
DB (Received Signal Strength) 233
PP (Peak Power) 234
Serial interfacing commands 234
API Enable 234
AO (API Options) 234
BD (Interface Data Rate) 235
NB (Parity) 236
SB (Stop Bits) 236
RO (Packetization Timeout) 237
D6 (DIO6/RTS) 237
I/O settings commands 238
IR (I/O Sample Rate) 238
IC (Digital Change Detection) 238
P0 (RSSI/PWM0 Configuration) 239
P1 (DIO11/PWM1 Configuration) 239
P2 (DIO12 Configuration) 240
P3 (DIO13/DOUT Configuration) 240
P4 (DIO14/DIN) 241
P5 (DIO15/SPI_MISO) 241
P6 (SPI_MOSI Configuration) 241
P7 (DIO17/SPI_SSEL ) 242
P8 (DIO18/SPI_SCLK) 242
P9 (DIO19/SPI_ATTN/PTI_DATA) 242
D0 (AD0/DIO0 Configuration) 243
D1 (AD1/DIO1/PTI_En Configuration) 243
D2 (AD2/DIO2 Configuration) 244
D3 (AD3/DIO3 Configuration) 244
D4 (DIO4 Configuration) 245
D5 (DIO5/Associate Configuration) 245
D8 (DIO8/DTR/SLP_RQ) 246
D9 (DIO9/ON_SLEEP) 246
LT (Associate LED Blink Time) 246
PR (Pull-up/Down Resistor Enable) 247
PD (Pull Up/Down Direction) 248
RP(RSSI PWM Timer) 248
DC (Device Controls) 248
DO (Device Options) 249
%V (Voltage Supply Monitoring) 249
V+ (Voltage Supply Monitoring) 249
TP (Temperature) 250
Diagnostic commands 250
VR (Firmware Version) 250
To Next Page
Loading...
Need help?
General
