XBee/XBee-PRO® S2C ZigBee® RF Module
11
VL (Version Long) 250
HV (Hardware Version) 250
AI (Association Indication) 251
Command mode options 251
CT (Command Mode Timeout) 252
CN (Exit Command mode) 252
GT (Guard Times) 252
CC (Command Character) 252
Sleep commands 252
SM (Sleep Mode) 253
SN (Number of Cycles Between ON_SLEEP ) 253
SP (Sleep Period) 253
ST (Time before Sleep) 254
SO (Sleep Options) 254
WH (Wake Host Delay) 254
PO (Polling Rate) 254
Execution commands 255
AC (Apply Changes) 255
AS (Active Scan) 255
WR (Write) 255
RE (Restore Defaults) 256
FR (Software Reset) 256
NR (Network Reset) 256
SI (Sleep Immediately) 257
CB (Commissioning Pushbutton) 257
&X (Clear Binding and Group Tables) 257
ND (Node Discovery) 257
DN (Destination Node) 258
IS (Force Sample) 258
Module support
XCTU configuration tool 261
Customizing XBee ZigBee firmware 261
XBee Bootloader 261
Programming XBee modules 261
Serial firmware updates 261
Invoke the XBee Bootloader 262
Send a firmware image 262
Writing custom firmware 262
Regulatory compliance 262
Enable GPIO 1 and 2 263
Detect XBee versus XBee-PRO 263
Special instructions for using the JTAG interface 264
Regulatory information
United States (FCC) 266
OEM labeling requirements 266
FCC notices 267
FCC-approved antennas (2.4 GHz) 268
Associated antenna descriptions 284
RF exposure 284
Europe (CE) 284
To Next Page
Loading...
Need help?
General
