API Operation Frame descriptions
XBee/XBee-PRO® S2C ZigBee® RF Module 197
Status
code
Transparent
mode string Description Status data Description
0x08 panID Match
JV
/
NW
with search option (DO80) has found
a matching network
panId(2) 16 bit PAN Identifier for network
0x09
Reject
LQIRSSI
JV/NW with search option (DO80) candidate
rejected because this beacon response is
weaker than an earlier beacon response.
0x0A Beacon Saved This beacon response is a suitable candidate
for an association request.
radioChannel(1) channel number ranging from 11 to 26 (0x0B to 0x1A)
radioTxPower(1) low level signed byte value for transmit power, values
range from 0xC9 to 0x05 inclusive
panid(2) 16 bit PAN Identifier for network
extendedPanId(8) 64 bit PAN Identifier for network
0x0B
AI AI value has changed.
AIStatusCode(1)
See a description of AI (Association Indication)
0x0C Permit Join
NJ
setting (Permit Join Duration) has
changed
value(1) See a description of the
NJ (Node Join Time)
command.
0x0D Scanning Active scanning has begun. ChannelMask(4)
A 32 bit value driven by the SC setting where bit positions
11 through 26 show which channels are enabled for the
upcoming Active Scan. See a description of SC (Scan
Channels).
0x0E Scan Error An error occurred during active scan. StatusCode(1)
0x0F Join Request High level request for a form/join.
0x10 Reject LQI Reject because LQI is worse than an already
saved beacon
lqi(1) link quality indicator
0x11 Reject RSSI Rejected because RSSI is worse than an
already saved beacon
rssi(1) relative signal strength indicator
To Next Page
Loading...
Need help?
General
