so, point the remote control at the projector and try again.
If the effective range of the remote control decreases, or it stops working, replace the
The emo e con o may a o ope a e he n a ed emo e senso s exposed o b gh
14
CONTROLS AND FUNCTIONS
3
INSTALLATION
C10 + B*#" /*+!"(/."%!
!
!
!
To install batteries in the remote control:
1. Slide the battery compartment cover in the direction of the arrow to remove it.
2. Install two AA batteries with the correct polarity.
3. Replace the cover.
1.
2.
3.
Notes on Batteries
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
Notes on Remote Control Operation
• In most situations, you can simply point the remote control at the screen which will reflect the IR signal from the re-
mote back toward the IR receiver on the projector. In some cases, however, ambient conditions may prevent this. If
•
• r t tr l f il t r t if t i fr r r t r i t ri t li t r r t li ti .
Figure 3-1: IR Reception Angles
To Next Page
Loading...
Need help?
General
