DINO 240RXT
63
18.4 MONTHLY INSPECTION (MAINTENANCE INSPECTION)
The inspection shall be performed by a person who is well familiar with the lift.
Task list for inspection:
- perform the measures of the daily inspection
- check the attachment points of the boom and the platform
- check the operation and condition of the platform levelling system
- perform visual inspection of the load-bearing structures
- chassis
- turning device
- telescope (fully extended)
- support outriggers and their joints
- welded seams for cracks, corrosion or breaches
- are the possible repair weldings duly executed
- check that the platform does not "drift" (refer to the service instructions)
- check that the outriggers do not "drift" (refer to the service instructions).
- hydraulic oil level
- check the electro-hydraulic rotating adaptor for leaks and seizures
- check the tyres and the tyre pressure
- check the wheel bolts and rims
- check the turning gear play
- check the proper operation of the drive motors and steering
- check the condition and attachment of the electric wires
- check the condition and attachment of the battery
- make sure that all signs, warnings and pictorials for operating controls and control equipment are
in place, in good condition and clean.
- check that the lift is clean all over
To Next Page
Loading...
