DINO 240RXT
67
- inspect the chassis
- general condition
- check the axle and its attachment to the chassis
- check the rims, the tightness of the wheel bolts, the tyres and the tyre pressure
- check the condition of the transport support of the boom
- perform a test run, test all operating controls, control the outreach according to the instructions
(see point “Testing the outreach limit switch”)
- also check the operation of the limit switches during the test run (refer to the service instructions)
- the overload limit switches on the safety devices
- the limit switches on the outriggers, which prevent the operation of the boom movements
- the limit switches on the tow-bar, which prevent the use of the outriggers
- after the test-loading make sure that the test loading has not caused any defects, such as fractures
or permanent deformations of dangerous nature, on the steel structures or other loaded parts
- draw up a protocol of the regular inspection with following articles:
1. inspection form
2. data of repair welds
a) date of repair
b) repaired by whom
c) what was repaired
- as the machine is ready for operation after the annual inspection, mark the inspection date on the
inspection plate affixed to the lift
18.6 EXTRAORDINARY INSPECTION
(INSPECTION AFTER AN EXCEPTIONAL SITUATION)
The inspection is required if the lift has been damaged in a manner which may affect its load-
bearing capacity or safe operation.
- in this case the lift shall be inspected according to the instructions for the annual inspection
- the lift shall be subjected to a test loading and a stability test
- a protocol shall be drawn up for the inspection
To Next Page
Loading...
