Dinstar DAG2000-24S - Page 23

4 Configurations on Web Interface
DAG2000-24/32SUser Manual
Copyright©2011-2020 Dinstar
18
range of numbers.
Static IP Address: Static IP address is a semi-permanent IP address and
remains associated with a single computer over an extended period of
time. This differs from a dynamic IP address, which is assigned ad
hoc at the start of each session, normally changing from one session to
the next.
If you choose static IP addre
ss, you need to fill in the following
information:
 IP Address: the IP address of the WAN port of the DAG2000;
 Subnet Mask: the netmask of the router connected the DAG2000;

Default Gateway: the IP address of the router connected the
DAG2000;
PPPoE: PPPoE is an acronym for point-to-point protocol over Ethernet,
which relies on two widely accepted standards: PPP and Ethernet. PPPoE
is a specification for connecting the users on an Ethernet to the Internet
through a common broadband medium, such as a single DSL line,
wireless device or cable modem. PPPOE IP address refers to IP address
assigned through the PPPoE mode.
If you choose PPPoE, you need to fill in
to fill in the following
information:
 Username: the account name of PPPoE
 Password: the password of PPPoE
 Server Name: the name of the server where PPPoE is placed
DNS Server
IP addresses of primary DNS server and standby DNS server are displayed.
Cloud Register
Status
Whether the DAG2000 device is registered to cloud or not.
System Uptime
The running time of the DAG2000 device since it is powered on.
NTP Status
Succeed: the DAG2000 device is sync to NTP server successfully;
Failed: the DAG2000 device fails to be sync to NTP server. Then you
should check network connection and the NTP server.
WAN Traffic
Statistics
Total bytes of message received and sent by WAN port.
Usage of Flash
Detailed usage of Flash memory
Usage of RAM in
Linux
detailed RAM usage of Linux core
Usage of RAM in
AOS
Detailed RAM usage of AOS