4 Configurations on Web Interface
DAG2000-24/32SUser Manual
Copyright©2011-2020 Dinstar
UDP Checksum Validation Choose whether to enable header checksum of UDP
DTMF Method Include SINGAL, INBAND and RFC2833
RFC2833 Payload Type
Preferred (Incoming Call)
For an incoming call, choose local or remote RFC2833 payload
type as the preferred payload type
RFC2833 Payload Type Local payload value, default value is 101
DTMF Gain Default value is 0 DB
DTMF Send Interval
The interval for sending DTMF signal. The default value is
200ms.
Send Flash Event
If this parameter is enabled, the DAG2000 device will send
flash-hook event to remote terminal, and thus user does not
need to handle it locally
Analog When Call in
Active
If this parameter is enabled, DTMF tone will be sent to analog
phone when there is a call
Coder Name
The device supports G.729, G.711U, G.711A, G.723,
G.726-16/24/32/40. When outgoing calls are made, G.729 will
be used.
Payload Type Each kind of coding has a unique load value, refer to RFC3551.
Packetization Time The time for voice packaging
Rate Voice data flow rate; It is defaulted by system.
Silence Suppression
Default value is ‘disabled’. If this parameter is enabled, Vo I P
transmission bandwidth can be saved, and meanwhile network
congestion can be avoided.
Codecs Preferred Choose local or remote codec as the preferred codec
4.9.4 Service Parameter
Service parameters include tiemout for dialing, digitmap,MWI message and so on.
To Next Page
Loading...
