Dinstar DAG2000-24S - 4 Configurations on Web Interface; 4.9 Advanced

4 Configurations on Web Interface
DAG2000-24/32SUser Manual
Copyright©2011-2020 Dinstar
30
similar to phone number or an actual phone number.
Primary/Seco
ndary SIP
Authenticate ID
SIP service subscriber’s authenticate ID used for authentication of
registration. It can be identical to or different from SIP User ID.
Primary/Secondary
Authenticate password
SIP service subscriber’s authenticate ID used for authentication of
registration
Offhook Auto-dial
An extension or phone number is pre-assigned here so that the
number is automatically dialed as soon as user picks up the phone
Auto-dial Delay Time
How long the auto-dial number is prolonged. If it is set as 3s, the
auto-dial number is dialed after 3 seconds pass.
DND (Do Not Disturb) the phone won’t receive any calls if this feature is enabled
Caller ID
Enable or disable caller ID for corresponding port
. If it is
disabled, the caller ID for the calls through the port won’t be
displayed.
Number for CFU
Call forward unconditional. All incoming calls will be forwarded
to pre-assigned number automatically
Number for CFB
Call forward on busy. If the line is busy, the call will be forwarded
to pre-assigned number automatically
Number for CFNRy
Call forward no reply. If the call is not answered, the call will be
forwarded to pre-assigned number automatically
Call Waiting
If call waiting is enabled, a special tone is sent if another caller
tries to reach you
Play Call Waiting Tone If call waiting tone is enabled, caller will hear special tone.
4.9 Advanced
4.9.1 Line Parameter
On the Advanced line page, you can configure FXS parameters which include for call
progress tone, auto gain control, fax parameters and so on.