Dinstar DAG2000-24S - Page 46

4 Configurations on Web Interface
DAG2000-24/32SUser Manual
Copyright©2011-2020 Dinstar
41
“Contact”
filled in in the ‘refer to’ field of a SIP message.
Third Party Do Not Send
18x Response
If this parameter is enabled, the third party will not send 18x
response during an attended transfer.
Send BYE when Recv
REF
ER Response
(Unattended)
If this parameter is enabled, the third party will send BYE to
release session after receiving REFER during a blind transfer.
Send New REGISTER when
Recv 423 Response
If this parameter is enabled, the value of ‘expires’ header will
be automatically updated and REGISTER will be re-sent after
receiving of 423 response.
CSeq Start with 1
If this parameter is enabled, the value of CSeq starts with
‘1’.
Forbid Invali
d m=line in
reINVITE
If this parameter is enabled, the device will prevent ‘invalid
m=line’ from being carried in the SDP of re-INVITE.
Call Confirm Tone
If this parameter is enabled, ring-back tone
will be played
when a call does not receive 180x response.
Call Waiting Response Code User can choose 180 or 182 as call waiting response code
RTP Mode in SDP when Call
Holding
Use ‘send only’ or ‘inactive’ as RTP mode during call holding.
Support Call
Waiting of
Huawei IPPBX
If this parameter is enabled, the device will s
upport call
waiting of Huawei IPPBX.
Accept Orphan 200 OK
If this parameter is enabled, the DAG2000 device will support
different ‘to-tag 200 OK’ in an INVITE session.
Called Number Preferred Choose P-Called-Party-ID header or Request-Line
Caller-ID Preferred Choose P-Asserted-Identity header or From Header
Report SDP Whatever If this parameter is enabled, SDP will be reported anytime
18x Response Preferred
Choose ‘18x Response with SDP’, ‘Last 18x Response’ or
‘Local Ring Tone Only’
Flashhook Operation Mode Choose Mode one, Mode two or Mode three
Attended Transfer Trigger Choose ‘Onhook’ or ‘Flashhook +4’