Dinstar DAG2000-24S - Page 52

4 Configurations on Web Interface
DAG2000-24/32SUser Manual
Copyright©2011-2020 Dinstar
47
Inquiry Phone Number
Dial*114# to obtain port account
Inquiry PortGroup Number
Dial *115# to obtain port group number
Setting IP Mode
*150*0#, means pppmodem, *150*1#, means static IP,
*150*2#, means obtain IP address by DHCP, *150*3#,
means pppoe.
Network Work Mode
*157*0#, set network work mode to routing mode;
*157*1#, set network work mode to bridge mode
Configure IP Address
*152*+IP, set gateway IP address
Network subnet mask
configure
*153*+subnet mask, set gateway subnet mask
Network Gateway
Configure
*156*+gateway IP, set gateway
Renew DHCP
*193#, set dynamic IP again
Reset Basic Configuration
Dial *165*000000# to restore default username/password
and network configuration
Reset Factory
Configuration
*166*000000#, reset factory
Restart Device
*111#, restart device
Call holding
During a call, dial*# into call hold.
（
Recovery the call
through hook flash or *#）
Call by IP
Directly dial the end user IP to call
Call Waiting Activate
*51#, enable call waiting function
Call Waiting Deactivate
*50#, forbid call waiting function
Blind Transfer
If the call transfer to 801, first hook flash and then dial the *
87 * 801#
Call Forward
Unconditional Activate
*72*+ phone number#, transfer the call from the phone
number
Call Forward
Unconditional Deactivate
*73#, forbid call forward unconditional
Call Forward Busy
Activate
*90*+ forward busy number#
Call Forward Busy
Deactivate
*91#, forbid call forward busy