Dinstar UC100 - 4.7 Extension

UC100 User Manual
39
Copyright @ 2011-2015 Dinstar
Dial Timeout (s)
The timeout value for dialing the first telephone number after off-hook
Ring Timeout (s)
The timeout value for the ringing of the phones of the FXO port when
there are incoming calls
No Answer Timeout (s)
The timeout value for ending calls which go out through FXO port
Polarity Reverse
If polarity reverse is on, call tolls will be calculated based on the changes
in voltage. If polarity reverse is off, you need to set the time to delay
offhook and call tolls will be calculated starting from the preset time.
DTMF Send Interval(ms)
The minimum interval between the sending of two DTMF tone
DTMF: Dual Tone Multi Frequency
DTMF Gain
Signal gain of DTMF
DTMF Duration (ms)
The minimum duration of a DTMF tone
Detect Caller ID
Whether to detect caller ID; default value is ‘On’
Ring Detection
Detect caller ID after ringing or detect caller ID before ringing
Dialplan
The rules for dialing
4.6.3 Codec
UC100 supports four codec modes, including G711A, G711u, G729 and G92. You can adjust the priority of
these four modes according to you needs.