35
CHAPTER 11 MAP SERVICES
The contents of the Services list (Source/Name) depends on input to SMARTBOX and the services authorized
by DISH. Options found on the Services page allow for services from satellite and ATSC to be enabled and/or
updated. Options are also provided to map the services to output channels and to set up a IP Input (limit four) and
a Program Guide.
The following options are available under Actions on the Services page (See Figure 19.):
• Apply — applies all changes made to the Details of each service. Be sure to click this when you have
completed changes.
• Undo Changes — deletes any recent changes made that have not been confirmed by the action of clicking
the Apply button.
• Quick Add — allows you to configure an individual service that the system is authorized for.
• Add IP Input — allows you to add up to four IP inputs (AKA Welcome Channels) for QAM output.
• Add EAS Input — allows you to add the Monroe R189 EAS (Emergency Alert System) input.
• Scan for Satellite Services — allows you to refresh the list of authorized satellite services.
• Scan for ATSC Services — allows you to scan for available ATSC services if an ATSC receiver blade and
antenna are installed.
• Remove All Services — allows you to remove all configured settings for services; the list of authorized
services will remain but will default to the pre-configured state.
The Information section shows how many services are available for configuration sorted by the source.
The following options are available under Filter:
• Expand All – opens the Details for every service listed under the current filters.
• Collapse All – closes the Details for every service listed under the current filters.
• Source Filter Dropdown – filters services based on the input source.
• Configured Services Checkbox – filters the service list so that only configured services are shown.
• Search – searches for call sign or service number entered into field.
• By Letter Filter – filters services based on first letter of call sign.
To Next Page
Loading...
Need help?
General