49
Figure 27 EVOLVE - Bitrate Configuration -IP Output
Replacing Existing Files
If you need to change the files being sent to the EVOLVE units, for example to update the software version being
broadcast, perform the following steps.
1. Under File to Replace in the Replace File section, select the specific file that you wish to replace in the
drop-down menu
2. Click the Select Replacement File button
3. Locate and select the replacement file from where it is stored on your computer.
4. Click the Upload and Replace File button.
5. Click the Refresh now button to see the replacement file listed as a service. The new file will retain the same
configuration as the service it replaced.
Set Up ATSC for EVOLVE
ATSC functionality on EVOLVE is supported in SMARTBOX software 0.2.16 or newer. You will need to scan for and
configure your ATSC services as normal (see Chapters 9 and 11). This allows ATSC locals to display on EVOLVE.
However, the SMARTBOX is not able to pull guide data from the ATSC signal. It will pull guide data from the
corresponding satellite local channel and send that to EVOLVE.
You need to tell the SMARTBOX which satellite channel corresponds to each configured ATSC service. To do this,
once you’ve scanned for and configured the ATSC services, navigate to the EVOLVE tab (See Figure 28.). Then
select the ATSC Event Data tab (See Figure 29.). The ATSC services you’ve configured are shown with no satellite
event data yet set.
Figure 28
To Next Page
Loading...
Need help?
General