37
Encrypted QAM Output
• Enable – Checked
• Type – QAM
• Output – Desired QAM Channel (QAM channel = 2 to 158; sub-channel = 1 to 99; i.e.,
10-1)
• Output Blade – Default is Auto; or select from list if using more than one QAM blade
• Format – Select Native
• Encryption – Desired Encryption (Pro:Idiom, Verimatrix or Lynk)
• Priority – 1-99; default is 99 (1 is highest, 99 is lowest)
• Virtual Channel Number – Assign number (used for the Program Guide)
Click Apply in the Actions box located on the upper left of the page to lock in the settings.
NOTE: Hospitality QAM Output (QAM 16 and QAM 48) — EIA STD Channel Plan, ITU-T J.83B Annex B, 256 QAM,
5.36 MSps, 6 MHz per channel, 54-1002 MHz range.
HD Over Coax Output
Use the following settings for transcoding to MPEG-2 for HD Over Coax.
• Enable – Checked
• Type – QAM
• Output – Desired QAM Channel (QAM Channel = 2 to 158; sub-channel = 1 to 99; i.e., 10-1)
• Output Blade – Default is Auto; or select output blade from list if using more than one QAM blade
• Format – Select MPEG-2
• Encryption – Clear
• Priority – 1-99; default is 99 (1 is highest, 99 is lowest)
• Virtual Channel Number – Assign number (used for PSIP data and the Program Guide)
Click Apply in the Actions box located on the upper left of the page to lock in the settings.
NOTE: HD Over Coax Output (QAM 16 and QAM 48) — EIA STD Channel Plan, ITU-T J.83B Annex B, 256 QAM,
5.36 MSps, 6 MHz per channel, 54-1002 MHz range.
NTSC Output
• Enable – Checked
• Type – NTSC
• Output – Desired NTSC channel from 7-78 (See Note below.)
• Output Blade – Select from list
• Priority – 1-99; default is 99 (1 is highest, 99 is lowest)
• Format
- Default = 16:9 resolution
- Letterbox = 4:3 resolution with letterboxed widescreen
- Centercut = 4:3 resolution with centercut on widescreen
• Virtual Channel Number – Assign Number the same as output NTSC channel for the Program Guide.
Click Apply in the Actions box located on the upper left of the page to lock in the settings.
To Next Page
Loading...