Controls - 38 JT40/JT40 All Terrain Operator’s Manual
Left Control Console
8. Autothrottle control To enable autothrottle mode,
press.
To disable autothrottle mode,
press again.
Autothrottle mode slows the engine to
low throttle after 15 seconds of
inactivity involving thrust, rotation,
drilling fluid flow, or pipeloader
functions. To return to high speed,
activate thrust, rotation, drilling fluid,
or an add/remove pipe cycle.
9. Remote engine start
control
To start engine from
operator’s station, push
button.
Release when engine starts.
IMPORTANT: This button works only
when key in set-up console is on,
operator is in seat, and battery
disconnect switch is closed.
Item Description Notes
To Next Page
Loading...
