EasyManuals Logo

DITEC DAS200TRF User Manual

DITEC DAS200TRF
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
42
EN
IP2348EN
Convenience battery 24V, DAS902BAT2 (00÷01)
When this parameter is set to On (01), with a 24V (UPS) battery
the operator will continue its normal operation in case of mains
power failure (flat batteries: last operation= opening /closing, see
parameter 36). Monitoring will be made if parameter 10 is set to
Convenience Monitoring (01).
Not approved in escape routes!
00 = Off.
01= On.
*NOTE: on DAS200TRG this display is not visible and is set to 00.
*NOTE: on DAS200TRF set to 00.
Emergency Unit Test Interval (04÷23hours)
The time set in this parameter controls the maximum time until
the next automatic test of the emergency unit is performed.
Battery Type (00÷02)
What type of battery that is mounted in the operator is identified
during the Learn.
00= No battery.
01= 12V (set parameter 43= 05).
02= 24V.
AUTOMATIC
Opening Delay For Lock (00÷99s x 0,1)
The time the opening is delayed (0.0-9.9sec) after an opening
impulse is given in operation mode selections OFF and EXIT.
If the DAS901BAT1 battery is used set parameter 43= 05.
Exit Lock (00÷01)
This parameter controls the electromechanical lock in the
operation mode selector setting EXIT.
00= Off. The electromechanical lock is not locked in EXIT.
01= On. The electromechanical lock is locked in EXIT, except
bistable lock.
NOTE: on DAS200TRF set to 00.
NOTE: If the Configuration Tool CT is used, disable the “learn
access”:
Learn AccessMMI Read accessMMI Write access
(DAS200TRG)
Stop Function (00÷01)
When this parameter is set to On (01) the Stop impulse is ena-
bled, otherwise it is disabled.
00= Off.
01= On.
Stop Configuration (00÷01)
00 = N.O.
01 = N.C.
Opening Max Force (02÷23N x 10)
The force applied from the operator to the door leaf during opening.
If the reopening maneuver occurs too abruptly, set parameter 49
with a value lower than the factory value (10), example 04 - 05.
Close Kick Force (00÷23N x 10)
The force applied from the operator to the door leaf during the
close kick.
Closing Max Force (02÷23N x 10)
The force applied from the operator to the door leaf during
closing.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DITEC DAS200TRF and is the answer not in the manual?

DITEC DAS200TRF Specifications

General IconGeneral
BrandDITEC
ModelDAS200TRF
CategoryDoor Opening System
LanguageEnglish

Related product manuals