dji FLIP - Connecting DJI Flip; RC Control; Auto Takeoff

• When using Mobile App Control, the max ight altitude of DJI Flip is 30 m and
the max ight distance is 50 m.
• Return to Home (RTH) is not supported in Mobile App Control. Maintain visual
line of sight within a controlled area.
• DO NOT y over water.
• DJI Flip will land automatically in the following situations. Make sure to observe
the operating environment to avoid DJI Flip to be lost or damaged when landing.
◆
Critical low battery.
◆
Positioning fails and DJI Flip enters Attitude mode.
◆
DJI Flip detects a collision but does not crash.
Connecting DJI Flip
1. Power on DJI Flip and wait for the system self-diagnostics to complete.
2. Enable Bluetooth, Wi-Fi, and location services on the smartphone.
3. Tap Connection Guide on the bottom right corner of the home screen in the app,
select the device model, and select Connect via Mobile Device.
4. Select the desired device in the search results. The Controls view is displayed after
connected successfully. When connecting the smartphone to DJI Flip for the rst time,
press and hold the power button of DJI Flip to conrm.
• You can also tap the QuickTransfer or Wi-Fi Devices panel on the home screen in
DJI Fly for Wi-Fi connection.
• To change the smartphone connected to DJI Flip, disable Bluetooth and Wi-Fi
on the currently connected smartphone before connecting DJI Flip to the new
smartphone.
3.3 RC Control
Auto Takeo
1. Launch DJI Fly and enter the camera view.
2. Complete all steps in the pre-ight checklist.
3. Tap
. If conditions are safe for takeo, press and hold the button to conrm.
4. The aircraft will take o and hover above the ground.
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 31