dji FLIP - Takeoff;Landing Procedures; Intelligent Flight Modes

Mode 3
Takeo/Landing Procedures
• DO NOT operate the aircraft when the lighting is too bright or too dark to
use the remote controller to monitor ight. You are responsible for the correct
adjustment of display brightness and amount of direct sunlight on the screen,
as to avoid diculty in viewing the screen clearly.
1. The pre-ight checklist is designed to help you y safely. Go through the full pre-ight
checklist before each ight.
2. Place the aircraft in an open, at area with the rear of the aircraft facing towards you.
3. Power on the remote controller and the aircraft.
4. Launch DJI Fly and enter the camera view.
5. Wait for the aircraft self-diagnostics to complete. If DJI Fly does not show any irregular
warning, you can start the motors.
6. Push the throttle stick up slowly to take o.
7. To land, hover over a level surface and push the throttle stick down to descend.
8. After landing, push the throttle down and hold until the motors stop.
9. Power o the aircraft before the remote controller.
Intelligent Flight Modes
It is recommended to click the link below or scan the QR code to watch the tutorial video.
DJI Flip User Manual
34 © 2025 DJI All Rights Reserved.