• A prompt will be displayed in DJI Fly if the transmission signal is weak
during ight. Adjust the remote controller orientation according to the attitude
indicator display to make sure that the aircraft is in the optimal transmission
range.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a
combo. Otherwise, follow the steps below to link the remote controller and the aircraft
after activation.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. In camera view, tap > Control > Re-pair to Aircraft. During linking, the status LED
of the remote controller blinks blue and the remote controller beeps.
4. Press and hold the power button of the aircraft for more than four seconds. The
aircraft beeps, and its battery level LEDs blink in sequence to indicate it is ready to
link. The remote controller will beep twice, and its status LED will turn solid green to
indicate linking is successful.
• Make sure the remote controller is within 0.5 m of the aircraft during linking.
• The remote controller will automatically unlink from an aircraft if a new remote
controller is linked to the same aircraft.
Operating the Touchscreen
• Note that the touchscreen is not waterproof. Operate with caution.
Screen Gestures
Back: Slide from the left or right to the
center of the screen to return to the
previous screen.
Return to DJI Fly: Slide up from the
bottom of the screen to return to DJI
Fly.
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 71
To Next Page
Loading...
