dji FLIP - Trigger Method

• It is important to set a suitable RTH altitude before each ight. Launch DJI Fly
and set the RTH altitude.
• The aircraft cannot sense obstacles during RTH if the environment conditions
are not suitable for the sensing system.
• GEO zones may aect the RTH. Avoid ying near GEO zones.
• The aircraft may not be able to return to a Home Point if the wind speed is too
high. Fly with caution.
• Pay extra attention to small or ne objects (such as tree branches or power
lines) or transparent objects (such as water or glass) during RTH. Exit RTH and
control the aircraft manually in an emergency.
• If the max altitude is adjusted below the current altitude during RTH, the aircraft
will descend to the max altitude rst and then continue returning to home.
• The RTH Altitude cannot be changed during RTH.
• If there is a large dierence between the current altitude and the RTH altitude,
the amount of battery power used cannot be calculated accurately due to wind
speed dierences at dierent altitudes. Pay extra attention to the battery power
prompts and warning prompts in DJI Fly.
• When the remote controller signal is normal during RTH, the pitch stick can
be used to control the ight speed, but the orientation and altitude cannot
be controlled and the aircraft cannot be controlled to y to the left or right.
Constantly pushing the pitch stick to accelerate will increase the battery power
consumption speed. The aircraft will brake and hover in place and exit RTH if the
pitch stick is pushed all the way down. The aircraft can be controlled after the
pitch stick is released.
• If the Home Point is within the Altitude Zone but the aircraft is not in the Altitude
Zone, when the aircraft reaches the Altitude Zone it will descend below the
altitude limit, which may be lower than the set RTH altitude. Fly with caution.
• The aircraft will exit RTH if the surrounding environment is too complex to
complete RTH, even if the sensing system is working properly.
• RTH cannot be triggered during auto landing.
Trigger Method
The user actively triggers RTH
During ight, you can trigger RTH by pressing and holding the RTH button on the remote
controller, or tapping
from the left side of the camera view and then pressing and
holding the RTH icon.
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 45