• DO NOT use other wireless devices operating at the same frequency as the
remote controller. Otherwise, the remote controller will experience interference.
• A prompt will be displayed in DJI Fly if the transmission signal is weak
during ight. Adjust the remote controller orientation according to the attitude
indicator display to make sure that the aircraft is in the optimal transmission
range.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a
combo. Otherwise, follow the steps below to link the devices.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. In camera view, tap > Control > Re-pair to Aircraft. During linking, the remote
controller beeps.
4. Press and hold the power button of the aircraft for more than four seconds. The
aircraft beeps, and its battery level LEDs blink in sequence to indicate it is ready to
link. The remote controller will beep twice to indicate linking is successful.
• Make sure the remote controller is within 0.5 m of the aircraft during linking.
• The remote controller will automatically unlink from an aircraft if a new remote
controller is linked to the same aircraft.
DJI Flip User Manual
76 © 2025 DJI All Rights Reserved.
To Next Page
Loading...
