• Make sure to follow all the steps to update the rmware, otherwise the update
may fail.
• Make sure the computer is connected to the internet during the update.
• DO NOT unplug the USB-C cable during an update.
• The rmware update will take approximately 10 minutes. During the update
process, it is normal for the gimbal to go limp, the aircraft status indicators to
blink, and the aircraft to reboot. Wait patiently for the update to complete.
Visit the following link and refer to the Release Notes for rmware update information:
https://www.dji.com/ip/downloads
6.4 Flight Recorder
Flight data including ight telemetry, aircraft status information, and other parameters
are automatically saved to the internal data recorder of the aircraft. The data can be
accessed using DJI Assistant 2 (Consumer Drones Series).
6.5 Post-Flight Checklist
• Make sure to perform a visual inspection so that the aircraft, remote controller,
gimbal camera, Intelligent Flight Batteries, and propellers are in good condition.
Contact DJI support if any damage is noticed.
• Make sure that the camera lens and vision system sensors are clean.
• Make sure to store aircraft correctly before transporting it.
6.6 Maintenance Instructions
To avoid serious injury to children and animals, observe the following rules:
1. Small parts, such as cables and straps, are dangerous if swallowed. Keep all parts out
of reach of children and animals.
2. Store the Intelligent Flight Battery and remote controller in a cool, dry place
away from direct sunlight to ensure the built-in LiPo battery does NOT overheat.
Recommended storage temperature: between 22° and 28°C (71° and 82°F) for
storage periods of more than three months. Never store in environments outside the
temperature range of -10° to 45°C (14° to 113°F).
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 79
To Next Page
Loading...
