3. DO NOT allow the camera to come into contact with or become immersed in water
or other liquids. If it gets wet, wipe dry with a soft, absorbent cloth. Turning on an
aircraft that has fallen in water may cause permanent component damage. DO NOT
use substances containing alcohol, benzene, thinners, or other ammable substances
to clean or maintain the camera. DO NOT store the camera in humid or dusty areas.
4. Check every aircraft part after any crash or serious impact. If there are any problems
or questions, contact a DJI authorized dealer.
5. Regularly check the Battery Level Indicators to see the current battery level and
overall battery life. The battery is rated for 200 cycles. It is not recommended to
continue use afterward.
6. Make sure to transport the aircraft with the arms folded when powered o.
7. Make sure to transport the remote controller with antennas folded when powered o.
8. The battery will enter sleep mode during long-term storage. Charge the battery to exit
from sleep mode.
9. Store the aircraft, remote controller, battery, and charger in a dry environment.
10. Remove the battery before servicing the aircraft (e.g., cleaning or attaching and
detaching the propellers). Make sure that the aircraft and the propellers are clean by
removing any dirt or dust with a soft cloth. Do not clean the aircraft with a wet cloth
or use a cleanser that contains alcohol. Liquids can penetrate the aircraft housing,
which can cause a short circuit and destroy the electronics.
6.7 Troubleshooting Procedures
1. How to solve the gimbal drift issue during ight?
Calibrate IMU and compass in DJI Fly. If the problem persists, contact DJI Support.
2. No function
Check if the Intelligent Flight battery and the remote controller are activated by
charging. If the problems persist, contact DJI Support.
3. Power-on and start-up problems
Check if the battery has power. If yes, contact DJI Support if it cannot be started
normally.
4. Firmware update issues
Follow the instructions in the user manual to update the rmware. If the rmware
update fails, restart all the devices and try again. If the problem persists, contact DJI
Support.
5. Procedures to reset to factory default
DJI Flip User Manual
80 © 2025 DJI All Rights Reserved.
To Next Page
Loading...
