Propellers Marked Unmarked
Illustration
Mounting Position
Attach to the motors of the
marked arm
Attach to the motors of the un-
marked arm
Notice
• Make sure to only use the screwdriver from the aircraft package for mounting
propellers. Using other screwdrivers may damage the screws.
• Make sure to keep the screws vertical while tightening them. The screws should
not be at a tilted angle to the mounting surface. After installation is complete,
check whether the screws are ush and rotate the propellers to check for any
abnormal resistance.
• The propeller blades are sharp. Handle with care to avoid personal injury or
propeller deformation.
• Make sure that the propellers and motors are installed securely before each
ight. Check to make sure the screws on the propellers are tightened after every
30 hours of ying time (approx. 60 ights).
• The screwdriver is only for mounting the propellers. DO NOT use the
screwdriver to disassemble the aircraft.
• If a propeller is broken, remove the two propellers and screws on the
corresponding motor and discard them. Use two propellers from the same
package. DO NOT mix with propellers from other packages.
• Only use ocial DJI propellers. DO NOT mix propeller types.
• Propellers are consumable components. Purchase additional propellers if
necessary.
• Make sure that all propellers are in good condition before each ight. DO NOT
use aged, chipped, or broken propellers. Clean the propellers with a soft, dry
cloth if there is any foreign matter attached.
• To avoid injury, stay away from rotating propellers or motors.
• To avoid damaging the propellers, place the aircraft correctly during
transportation or storage. DO NOT squeeze or bend the propellers. If propellers
are damaged, the ight performance may be aected.
• Make sure the motors are mounted securely and rotating smoothly. Land the
aircraft immediately if a motor is stuck and unable to rotate freely.
• DO NOT attempt to modify the structure of the motors.
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 51