3. When installing, hold the end of the propeller with one hand, ensuring the DJI logo
is facing up. Gently lift the propeller guard and insert the propeller through the gap
from below. Meanwhile, use the screwdriver with the other hand to assist in aligning
the screw hole of the propeller with the protrusion on the motor. After aligning the
hole, press down on the propeller a few times with the screwdriver to ensure it is
properly seated. Place the screw on the screwdriver, and then tighten the screw. After
installation, gently lift the propellers upwards to ensure they are securely fastened!
DJI Flip User Manual
© 2025 DJI All Rights Reserved. 53
To Next Page
Loading...
