revision: 0
FlexxPump 125 (24V)
User Manual
39
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
Changing the value of the pause time h:
If you want to change the value of the pause time h, move the activation and pro-
gramming key back to the action area.
Ü In the LCD the next higher (h
is
+ 1) adjustable value of the pause time h is displayed.
The green LED lights up as long as the activation and programming key is on the action
surface; the other values of the pause time h run through one after the other. However,
you can also remove the activation and programming key from the action area and
bring it back to the action area shortly afterwards to reach each value one after the
other. If the nal value of the pause time h of h=240 is reached and no value has been
selected, the menu returns to h=01 and the cycle can be restarted.
As long as the new value you choose for the pause time h (h
new
) is displayed in the
LCD, remove the activation and programming key from the action area.
Ü The yellow LED disappears, the green LED and the LCD ash 2x. The selected new
value (h
new
= h
is
) of the pause time h has now been accepted. The submenu will now
automatically take you to the values of the number of cycles c.
No changing of the value of the pause time h:
If you do not want to change the value of the pause time h, the activation and pro-
gramming key must remain removed from the action area immediately after entering
the PRO-Menu.
Ü The LCD as well as the green LED ashes twice and the pause time h is displayed
in the LCD. The submenu now automatically takes you to the values of the number of
cycles.
The LCD now displays the currently set value of the number of cycles c (c
is
). Now you
have the possibility to change the values of the number of cycles c.
Changing the value of the number of cycles c:
If you want to change the value of the number of cycles c, move the activation and
programming key back to the action area.
Ü In the LCD the next higher (c
is
+ 1) adjustable value of the number of cycles c is
displayed. The green LED lights up as long as the activation and programming key is
on the action surface; the other values of the number of cycles c run through one after
the other. However, you can also remove the activation and programming key from the
action area and bring it back to the action area shortly afterwards to reach each value
one after the other. If the nal value of the number of cycles c of c=10 is reached and
no value has been selected, the menu returns to c=01 and the cycle can be restarted.
As long as the new value you choose for the number of cycles c (c
new
) is displayed in
the LCD, remove the activation and programming key from the action area.
Ü The yellow LED disappears, the green LED and the LCD ash 2x. The selected new
value (c
new
= c
is
) of the pause time h has now been accepted.
No changing of the value of the number of cycles c:
If you do not want to change the value of the number of cycles c, the activation and
programming key must remain removed from the action area immediately after entering
the PRO-Menu.
To Next Page
Loading...
