DLS FlexxPump 125 - Page 40

revision: 0
FlexxPump 125 (24V)
User Manual
40
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
Ü The LCD as well as the green LED ashes twice and the number of cycles c is dis-
played in the LCD.
 Insert the activation and programming key into the hole provided on the housing of
the FlexxPump 125.
The PRO-Menu can only be reached from the ON mode (FlexxPump 125 switched
on).
When you enter the PRO-Menu, you will return to the ON mode.
If you have made changes to the values of the pause time h or the values of the
number of cycles c in the PRO-Menu and the FlexxPump 125 is otherwise ready for
operation (cartridge fitted), the FlexxPump 125 will immediately start with the calculated
waiting time until the next pause.
 Observe the back pressure values displayed on the LCD if they are of interest to
you.
During the pause process, the green LED lights up; in addition, the counterpressure
for the stroke is displayed in the LCD.
The parameters that can be set for the pause time h and the number of cycles c and
their respective permissible values are specied as follows:
h := Pause time in hours (h).
The dispensing time can be set between 1 | 2 | 3 | ... | 240 hours.
Values of 1 | ... | 99 are displayed in the LCD with h in front, values of 100 | ... |
240 without h in front.
The time counter integrated in the FlexxPump microelectronics starts counting
the pause time h after a successful and completed dispensing cycle.
c := Number of cycles within a dispensing cycle (c).
The number of cycles c can be set between 1 | 2 | 3 | ... | 10 strokes.