DMC SuperSigma2 QRM - Page 47

SuperSigma2 QRM PMS – V01.02.02 17-1-2020 Page 47 (58) ©2019 DMC GmbH Herten Germany
… Errors continue from previous page
Base
fault
Code
Description
Sub
fault
code
Description
Hard error faults - Immediately stops pulsing and open line contactor – Reset only by a key switch recycle
34
Motor Module parameter inconsistency
> 0
See table "Motor sub error codes"
35
Current sensor calibration fault
1
Could not initialize the calibration
2
Time out during calibration
36
Controller temperature over 100 degree
-
39
Generic time out
1
Time out on configuration upload
2
Time out on getting stable inputs
3
Time out on motor ready
40
System Fault
> 0
Internal system error Contact DMC