DMC SuperSigma2 QRM User Manual

SuperSigma2 QRM for
Permanent Magnets Synchronous motors
Quick Reference Manual V01.02.02
This user manual details the features of the standard controller range:
(for more detailed information contact DMC)
PMS range for Permanent Magnet Synchronous Motors 24-96V, 250-600Arms
Modification History:

DMC SuperSigma2 QRM Specifications

General

Brand	DMC
Model	SuperSigma2 QRM
Category	Industrial Equipment
Language	English

Summary

DMC Philosophy and Introduction

SuperSigma2 Variants

Controller Features

Technical Specifications

Electrical Specifications

Details voltage and current ratings and frequency.

Environmental Specifications

Covers IP rating, vibration, temperature, and humidity resistance.

Mechanical Specifications

Installation Instructions

Safety Guidelines

Crucial safety precautions for working with the controller and vehicle.

Mechanical Installation and Cooling

Procedures for mounting the controller and ensuring adequate heat dissipation.

Contactors, Software Update, and Power Up Delay

EMC Guidelines

Cable Routing

Guidance on routing power and signal cables for emissions control.

Calibrator Operation

The Calibrator

Details the calibrator's functions, interface, and modes.

Calibrator Map and PC Programmer

Dashboard Display Overview

General Information and Setup

Overview of display windows, buttons, fault indication, and settings adjustment.

Display Features Setup

Display Icons Reference

Parameters and Traction Adjustments

Acceleration and Deceleration Settings

Adjustments for acceleration and deceleration delays and ramp times.

Braking and Creep Settings

Configuration of neutral braking, foot braking, creep speed, and ramp times.

Advanced Traction Parameters

Neutral Braking and Hill Hold

Pump Adjustments

Status Menu Overview

Status Tables Reference

Controller Setup - Traction

Controller Setup - Pump

PMS Motor Auto Tuning

Setting Up Auto Tuning

Basic parameters required for the auto-tuning process.

PMS Motor Auto Tuning Parameters

Initiating Auto Tuning

Auto Tuning Errors

Recalculation Procedure

PMS Motor Setup

PMS Motor Advanced Settings

Limits Setup

BDI Battery Discharge Indicator Settings

CAN Bus Setup

Fault Log

Test Menu for Traction

Test Menu for Pump

Debug and About Information

Thermal Motor Management

Diagnostics - Error Codes

Drive and Accelerator Error Codes

Soft and Hard Error Faults

Hardware and CAN Node Errors

PMS Motor Sub Error Codes

Graphics and Schematics

Accelerator Characteristics

Graphs showing different accelerator input curves.

Controller Thermal Cutback

Graph illustrating thermal overload protection for the controller.

PMS Controller Wiring

Traction Connector Pin Assignments

Detailed pinout for the 35-way vehicle interface connector (Traction).

Traction Light Wiring Example

Pump Controller Wiring

Pump Light Wiring Example

CAN Bus Wiring

CAN Bus Wiring with DMC Display

Example wiring for a CAN bus with an attached DMC display.

Display and Power Wiring

Mechanical Drawings

Available Application Notes

Contact Information